BUSCAR / SEARCH

octubre 21, 2010

INVITACION II SALON DE ARTE VISUAL CONTEMPORANEO




II SALÓN DE ARTE VISUAL CONTEMPORÁNEO 2010

El 22 de octubre a las 19:00 hrs. será la inauguración,
y estará presente hasta el 21 de Noviembre de 2010.
En el Jardín Borda, Av. Morelos 271 ,
Centro, Cuernavaca, Morelos


mi participacion es con la obra:
magenta (raices)
26 x 36 cm
septiembre de 2010
no disponible


II CONTEMPORARY VISUAL ART SHOW 2010

On 22 October at 19:00 hrs. will be a launch
and will be there until November 21, 2010.
In the Borda Gardens, 271 Avenida Morelos,
Centro, Cuernavaca, Morelos

II SHOW l'art visuel contemporain 2010Le 22 Octobre à 19h00. sera le lancement d'unet sera là jusqu'au 21 Novembre 2010.Dans les jardins Borda, 271 Avenida Morelos,Centro, Cuernavaca, Morelos

3 comentarios:

Ramón Abad dijo...

Genial, Rodrigo...

isabella kramer - veredit dijo...

Una pintura de delicadeza mágica y maravillosa expresión. Me gusta mucho. Felicitaciones a este trabajo.

saludos
veredit

i1zyx3irfe dijo...

The common defects in injection-molded plastics and their causes are summarized in the desk under. Some issues in injection molding could only require optimization of parameters to mitigate the defect. However, it may be troublesome and expensive to address injection molding issues especially when the design of the mould is inflicting the defect. Lightweight thermoset polyurethane is the most frequently produced part by RIM, though RIM can also be|may also be|can be} employed in producing nylon, polyesters, and others. The RIM Cat Sweaters of polyurethane begins with the polymer liquids polyol and isocyanate stored in massive reservoirs. These polymers are constantly recirculated inside the system; they are pumped from the reservoir to a multi-stream mix-head on the mould tooling after which back to the reservoir.